JETI Model Power Ion 3100 2S1P Battery pack

JETI Model Power Ion 3100 2S1P Battery pack

SKU: 22985455
GTIN: 8595245917050
Category: Electronic Ignition for Titan ZG engines
Manufacturers:

58,90 €

incl. 19% VAT , plus (Standard)

2 or more in stock
Delivery time: 2 - 4 Workdays (DE - int. shipments may differ)

pcs.

Description

JETI Model Power Ion 3100 2S1P Battery pack

Power-Ion accumulators are battery packs suitable to power the receiver, ignition and servos in the model.

The main advantages of Power-Ion accumulators include high mechanical resistance due to keeping in a metal case. The accumulators are also characterized by a long cycle life. No balancer is needed for their operation and in case the current is higher than 150A, short circuit

protection is activated. Overcharge protection is activated if the charging voltage is higher than 5V per cell.

The accumula-tors are functional even at very low or very high temperatures (-10 - +60°C). Each pack is provided with one two-wire cable with the JR connector for charging and with one two-wire cable with the MPX connector for connection to the model. Both cables are of the same length.

The accumulators are supplied in a plastic case and are fastened to it by Velcro. The case itself is screwed to a model using anti-vibration rubber grommets, see the picture below. Pay attention to correct placing of the brass washer. Its wider part should be in contact with the assembly board to which the battery case is mounted to avoid extruding the material.

Specifications:

Configuration: 2S
Nominal voltage: 7,2V
End-of-charge voltage: 8,4V
Capacity: 3100mAh
Permanent discharge current: 20A
Max. discharge current: 40A
Max. charge current: 4A (über MPX Stecker)
Balancer connector: no
Cable length (1x MPX Kabel + 1x JR Kabel): 135mm
Weight: 136g (incl. Holder) / 104g (w/o Holder)
Dimensions: 104x47x32mm (incl. Holder) / 70x39x20mm (w/o Holder)